If you go this route, the guy in Olympia might well be your best bet. There is also the physical size: will the Technics fit? These might not be optimal for this, as is, being set up to optimize performance of a ceramic cartridge. To install the new turntable, you would have to connect to the power lines, and the signal cables would have to go through a phono pre-amp to the correct inputs in the amp. A phono preamp reverses this change to the signal, and amplifies it to a level the amp can deal with, and is therefore necessary. ![]() It is also truer to what is on the record.īass is diminished and treble is boosted, a lot, in order to have a readable groove. The signal generated my a magnetic cartridge is maybe a thousandth of that of a ceramic cartridge. The old ceramic cartridges put out a strong enough signal that amps could deal with them, and the natural properties of the system was self-correcting re spectral balance. Some of those old consoles had a harness to connect the turntable that included power for the turntable, and a line to switch on the console when you put a record on, so be very careful what you hook up there. In any case, can someone please tell me how I might connect the Technics turntable to the original receiver in the old Magnavox console? I would be most grateful for any and all help. Order oysters, clams, mussels, geoduck, merchandise and more. Perhaps someone out there knows what I'm trying to describe? I hope so. Ceramic Miniature Hand Painted Glazed Ceramic Art Tile - Lanzarote - Devil. A few people have mentioned that the neck of the clam. Moreover, it is common for weeds and barnacles to grow off of this clam. In the Horseneck clam, you have a big hole on the top of the surface and it is easier to spot them. I tried to take a picture of this connection by laying on my back with a camera stuck upside down inside the back of the cabinet, but don't know how to put the resulting shot into this message. The major difference between the Horseneck and the Geoduck clam is that the neck is somewhat different. Very awkward location inside the console, too. Instead, that end of the two wires poke directly into a little white plastic "grid" -it looks like bare wires poked into a grid of squarish little holes in a small white plastic box. However, the old Magnavox connections involved two very old RCA connectors and a ground cable at the turntable end, but then at the end that connects to the magnavox receiver mounted inside the console, there are no RCA connectors. The turntable connected to the receiver via a cable with two RCA connectors at each end. So I found a Technics sl-q300 that worked beautifully with the receiver and huge speaker the fellow had it hooked up to. The turntable changer needed work, but the only qualified repair fellow in the Puget Sound region I could find, a fellow in Olympia to whom I was sent by the folks at Rainy Day Records, advised me to find a somewhat newer turntable of good quality rather than pay for the time he would have to charge to fix the Magnavox. ![]() I have a late 60's - early seventies Magnavox console hi-fi. But I want to learn, so I hope all you experts will be patient. I'm brand new to vintage hi-fi repair, pretty ignorant about how old audio equipment works.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |